The Smiling Journal

For all your creative needs!

DIY Fingerless Gloves!

Wanna make your outfits more exciting? Wear cute, upcycled fingerless gloves!

image

You will need:
– One or two socks
– Scissors
– Permanent marker

Optional extras:
– 2 x 30cm pieces of ribbon

If you have two socks:
Start off by cutting the toe end off one of the socks. Now, put the sock on your hand as if it were a glove, with the elastic part around your knuckles.

image

Make a small dot with the permanent marker at the base of your thumb (not the tip).
Take the sock off again, and poke the scissors through where the mark is. Now put the sock back on your hand, and stick your thumb through the hole. Use the scissors to widen the hole very carefully! Its easy to cut it too big, so keep checking to see if your thumb is comfortable.

image

You’re pretty much done! All you need to do is cut the end to the length you want it, and repeat this process for the other sock!

image

If you have only one sock:
Start off by cutting the sock above the heel part, and below. You should now have a strip with the heel part on it (you can throw this away).

image

Next, put the piece of the sock with two openings on your hand as if it were a glove, with the elastic part around your knuckles. (these next few steps are the same as above, but I’ve written them again).
Make a small dot with the permanent marker at the base of your thumb (not the tip).
Take the sock off again, and poke the scissors through where the mark is. Now put the sock back on your hand, and stick your thumb through the hole. Use the scissors to widen the hole very carefully! Its easy to cut it too big, so keep checking to see if your thumb is comfortable.

Next, grab the last piece of the sock. Cut the toe part the same distance from the thread line as the width of the elastic bit of the other half of the sock. Like so:

image

image

Now, just cut them to the length you want them!

Optional extra:
If you don’t want the glove to gape open at the wrist, you can do this step.
Using the scissors, carefully poke small holes all the way around the wrist end of your glove. Now, weave the piece of ribbon in and out of the holes, all the way around. Repeat this for the other glove, and you’re done! You can tie the ribbon ends into a nice bow if you like! 🙂

image

Leave a comment »

Leg Warmers!

Just had to share this!
Seeing as its the middle of winter here, I’ll make a post on how to make leg warmers!!
Now, this project is not my own (sadly) so I’ll have to link you to the site. But not before I show you the ones I made!!! Oh yeah!!!

image

And here’s how to make them:
http://abeautifulmess.typepad.com/my_weblog/2010/03/diy-leg-warmers-from-promise.html

Happy creating!!

image

Leave a comment »

%d bloggers like this: